I got a pegbar from lightfoot animation supplies.I know im supposed to put it on my scanner but i dont know how.For now i just put tape on the back of the peg bar but i dont think this isnt a stable method.SO how do you fasten a peg bar to a scanner?
thanks for your time
well, I just use tape and It's always worked fine for me. I'm guessing that you don't want to permently attatch it..so, perhaps the gummy tacky stuff might work too.
---
www.wolfmovie.com
Perhaps Velcro? :)
I do not know, but if you paper has wholes could you not just adjust the image after you scan them in. I am thinking that even with a pig bar there is going to be a little slop. I am quessing.
I've always taped mine to the edge of the scanner, running the tape over the top of the pegbar next to the outside pegs. The tape goes onto the scanner glass a bit, but it shouldn't be a problem unless you're using the whole 12 fields.
We use a paper feed machine. No peg bar required
The Brothers McLeod
[SIZE=2]brothersmcleod.co.uk[/SIZE]
I use a little rubber cement. the bar is easy to pull off and the glue doesn't leave any marks
www.MattOrnstein.com
Character Animator - Lucas Arts
thanks everyone p.s.if anyone has any other ideas please tell me. :D
tape def. works nicely and if u need to switch scanners you can remove it quite painlessly. gumming it is a bit permanent.
yeah but i have a plastic reg bar that only cost $5 so if i lose $5 its certaintly not the end of the world.
you do have a good point though. :D and i know some peg bars cost $20 if they are matal and i can see why that would be a problem.
its not the peg bar youll ruin. ull shite up the scanner
im sorry my misatake.